Hi Everyone. Well, after 15 years the RV-Dreams Community Forum is coming to an end. Since it began in August 2005, we've had 58 Million page views, 124,000 posts, and we've spent about $15,000 to keep this valuable resource for RVers free and open. But since we are now off the road and have settled down for the next chapter of our lives, we are taking the Forum down effective June 30, 2021. It has been a tough decision, but it is now time.


We want to thank all of our members for their participation and input over the years, and we want to especially thank those that have acted as Moderators for us during our amazing journey living and traveling in our RV and growing the RV-Dreams Family. We will be forever proud to have been founders of this Forum and to have been supported by such a wonderful community. Thank you all!!

Members Login
Username 
 
Password 
    Remember Me  
Post Info TOPIC: Slide-out Cover Collects Water


RV-Dreams Community Member

Status: Offline
Posts: 3
Date:
Slide-out Cover Collects Water


I have a 2007 Dutch Star with what seems to be an age old problem.  My largest slide-out collects water and sags everytime it rains.  The smaller covers do fine.  I have tried the Airwedge, which is an inflatible air bag that goes between the slide-out roof and cover.  But it is too fat to push between the roof and cover.  Or if I deflate it until it fits, it's too flimsey to be pushed more than a couple of feet and the slide-out is 13 feet long.  I also tried making a PVC "pipe on stilts" contraption I saw at an RV internet site figuring that it would push up the middle and the water would roll off.  But the water collected on the cover both between the coach and the pipe and the pipe and the end of the cover.  I have also looked at the cover literature to see if it can be tightened so it won't sag.  But nothing was said about how to tighten it.  I've looked at other motorhomes and most seems to do the same thing.  Any suggestions here?
 

__________________


RV-Dreams Family Member

Status: Offline
Posts: 33
Date:

This is interesting because I was talking to a guy last night, and he had slid a piece of PVC fencing rail between the awning and the slide-out.  It was just tall enough to make a tent sort of, and shed off all the water.

__________________
Tim & Cathy and our traveling buddy, Suzy
2000 Gold Wing
2007 Ford Edge (to be sold when our cabin sells)
F450 King Ranch
No Trailer yet :(


RV-Dreams Family Member

Status: Offline
Posts: 3722
Date:

Tightening requires two people with muscles and the know how to do it right. Those springs are strong.
A friend has a multi-piece PVC pipe tent that he uses that lifts the middle of the slideout full length. He puts it in in pieces and takes it out the same way. He made it himself. He has a 2002 Dutch Star.

-- Edited by bjoyce at 19:58, 2007-07-16

__________________

Bill Joyce,
40' 2004 Dutch Star DP towing an AWD 2020 Ford Escape Hybrid
Journal at http://www.sacnoth.com
Full-timing since July 2003



RV-Dreams Community Member

Status: Offline
Posts: 3
Date:

My explanation of what I have tried already wasn't clear, I guess. The "PVC pipe on stilts" was like the "tent" you have suggested. All it did was cause 2 puddles, one on each side of the peak of the tent. I may not have had the tent peak tall enough. I will try to raise the tent height and see what happens next time it rains.

Thanks for the suggestions and I'll let you know what happens next time it rains.

__________________


RV-Dreams Family Member

Status: Offline
Posts: 289
Date:

I would think one could make a PVC wedge with enough cross braces to keep from puddleing. Try spacing a cross brace either vertical or hortizontal about 1 foot apart, 18 inches at the most.  This would be quite an assembly, some of it could be glued together and some of it just slip into place as you where installing it. 
 
Flyone



__________________

Team Cockrum:
2001, F250 Diesel, 2012 33 FT. CrossRoads Cruiser Fifth Wheel



RV-Dreams Family Member

Status: Offline
Posts: 319
Date:

Hi!

I had the same problem on our American Tradition and was able to solve the problem.  My awning was a Carfree canvas  awning and was 18 feet long.  You haven't said whether your slide out cover is vinyl or canvas but I'll bet it is a canvas material.  If it is, these canvas materials can lose a little of their ability to shed water just like the old tarpolin tents did.  The loss of repellant ability causes the water to soak into the cloth making the cloth itself heavier.  The heavy cloth sags of its own weight temperarily bending the awning roller tube in at the center creating the pools or making them worse.  The repellant abitlity of the canvas can be restored quite easily with a can of Scotch Guard water repellant or other suitable spray.  There are several commercially available.  One should clean the canvas first with soap and water to remove any residual dirt.  A dirty canvas will hold water too.  Once the canvas is clean, spray it heavily with the repellant spray.  Of course you must have a dry canvas to apply the repellant spray and several coats won't hurt a thing.  This won't stop the awning from pooling if it mounted too flat or is too lose but it will help repel the water if the PVC pipe ridge is used.

An alternative might be to look at raising the awning rail which attaches the awning to the body of the coach.  This would give the awning move slope aiding in water drainage.  That may not be possible on you coach but it is an idea that you could check on.  I wouldn't remove the old rail though.  I would add a new one above the old one.  Removing the old rail and moving it might create some leaks.  Good luck.

__________________
Full timing since 1/1/2005
American Tradition & Jeep Wrangler
www.howethsjournal.blogspot.com


RV-Dreams Community Member

Status: Offline
Posts: 3
Date:

Thanks everyone for your comments.

What I did was to make my PVC "tent" a little higher and it worked like a charm.  I took 3/4" PVC pipe and put in a verticle support every 3' for the length of the 12' slide - actually I have 2, 6'sections.  I then wrapped each 3' section with insulating material to cushion the pipe against the vinyl cover.  This took the slack out of the cover and the rain water now just rolls off with no puddling.  Total cost for all the material was under $15.  I can place the tent poles under the slide cover from the roof, so I don't have to get my ladder out.  I just go up the rig's ladder mounted on the rear.  It takes only a couple of minutes and the pieces can be disasembled for easy storage.

Hope this helps anyone else with a similar problem.

__________________


RV-Dreams Family Member

Status: Offline
Posts: 58
Date:

I used to blow up balloons, and put them under mine, the sausage shaped ones, and keep the strings long, so that I could retrieve them.  Penny, TX

__________________
Don't drink and drive, ever.
I loved my dog, he was not motivated by money !!
Have a safe one. www.pennys-tuppence.blogspot.com


RV-Dreams Family Member

Status: Offline
Posts: 518
Date:

Another option:
www.awningairwedge.com
about $40
Airwedge_for_website_TM_400x201.jpg

__________________
www.RVDude.com


RV-Dreams Community Member

Status: Offline
Posts: 2
Date:

I have a slideout topper that collects water as well. My question is will it hurt anything? Thanks

__________________
Daniel Phipps


RV-Dreams Family Member

Status: Offline
Posts: 1094
Date:

Not really hurts anything except if someone is standing close to the slide when you bring it in and they receive a cascade of water. Ours looks full, I just pull the slide in and let it dump then put the slide back out.

Barb


__________________

Barb & Dave O'Keeffe

2002 Alpine 36 MDDS (Figment II), 2018 Ford C-Max HYBRID

Blog:  http://www.barbanddave.net

SPK# 90761 FMCA #F337834



RV-Dreams Community Member

Status: Offline
Posts: 2
Date:

Thanks Barb. I've done the same. Wasn't sure if the weight of the water would hurt the slideout when you let it in or not.



__________________
Daniel Phipps


Host

Status: Offline
Posts: 1224
Date:

Pooling water on the slideout toppers will stretch the fabric, especially on larger slideouts.  The stretched fabric will then tend to billow and flap more in windy conditions.

Also, pooling water over time can stretch the seams on the fabric or the stress points and cause premature tearing.  Water that leaks through and then settles on the top of the slideout could leak into the rig depending on the condition of slideout seals, the condition of the seams on the top of the slideout, and how level you are when parked.

I'm not suggesting that you remove the water after every rain, but water that pools for too long can have an effect on the life of the toppers. 



__________________


RV-Dreams Family Member

Status: Offline
Posts: 258
Date:

One thing I've noticed on some rigs is a roller support on the longer covers. Ours doesn't have one, and there seems to be a fair amount of deflection in the roller tube. Would that be a worthwhile investment?


__________________

Jim & Diana

2007 Colorado 31 RL  5th wheel

2008 F350 Larait SRW 6.4L Diesel, crew cab, long box - PullRite Superglide 15K hitch

Follow us at:  http://www.exploRVistas.com



RV-Dreams Family Member

Status: Offline
Posts: 3722
Date:

Diana and Jim wrote:

One thing I've noticed on some rigs is a roller support on the longer covers. Ours doesn't have one, and there seems to be a fair amount of deflection in the roller tube. Would that be a worthwhile investment?


 Yes, since we recently had our slide topper fail because of it.  The tube sagged enough to hang up when the slide was brought in.  We have been going without a topper since, but are getting a new one installed next week.  My knees are not up to getting on the roof to check for branches, etc., every time we move.



__________________

Bill Joyce,
40' 2004 Dutch Star DP towing an AWD 2020 Ford Escape Hybrid
Journal at http://www.sacnoth.com
Full-timing since July 2003



RV-Dreams Family Member

Status: Offline
Posts: 224
Date:

My DH gets up onto the roof after a rain and sweeps the slide toppers off. We had the PVC contraption as well, but if we needed to pull the slides in due to a bad storm, it made it a pain.

__________________

Laurie & George Owen

www.owensontheroad.blogspot.com 
2006 Chevrolet Silverado 3500 DRW 
2017 Vilano 365RL

 

Full time since 10/1/2012!

Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.

Tweet this page Post to Digg Post to Del.icio.us