Hi Everyone. Well, after 15 years the RV-Dreams Community Forum is coming to an end. Since it began in August 2005, we've had 58 Million page views, 124,000 posts, and we've spent about $15,000 to keep this valuable resource for RVers free and open. But since we are now off the road and have settled down for the next chapter of our lives, we are taking the Forum down effective June 30, 2021. It has been a tough decision, but it is now time.
We want to thank all of our members for their participation and input over the years, and we want to especially thank those that have acted as Moderators for us during our amazing journey living and traveling in our RV and growing the RV-Dreams Family. We will be forever proud to have been founders of this Forum and to have been supported by such a wonderful community. Thank you all!!
Our SureFlo water pump usually purrs/humms when it ran and stopped once pressurized. We had good water pressure and life was good. Then it started pulsating when it ran and the water pressure really dropped. I replaced the pump and all was good again for a couple of months, now this new one is doing the same thing. Any ideas?
Sometimes you will get debris in the lines from original construction, water fills at various locations where the well water has stuff in it and some water will cause calcium build up. Here's what I would do
1. remove the screens at each faucet/shower head and clean out the crud
2. While the faucet screen are off flush the lines to clear the lines.
3. If the above doesn't work remove the pump and check the inlet and outlets for crud.
Your tank may need to be flushed as well to remove any debris.
__________________
"Small House, Big Yard "
"May the FOREST be with you" Alfa See-Ya 5'er and 2007 Kodiak C4500 Monroe
