Hi Everyone. Well, after 15 years the RV-Dreams Community Forum is coming to an end. Since it began in August 2005, we've had 58 Million page views, 124,000 posts, and we've spent about $15,000 to keep this valuable resource for RVers free and open. But since we are now off the road and have settled down for the next chapter of our lives, we are taking the Forum down effective June 30, 2021. It has been a tough decision, but it is now time.
We want to thank all of our members for their participation and input over the years, and we want to especially thank those that have acted as Moderators for us during our amazing journey living and traveling in our RV and growing the RV-Dreams Family. We will be forever proud to have been founders of this Forum and to have been supported by such a wonderful community. Thank you all!!
I haven't found this tripod talked about anywhere on the forum so thought I would share. Check out www.tv4rv.com I purchased one last September and what a difference...it makes setting up your dish a snap. It's a surveyor type of tripod and mast that comes with a compass and level as well accessories for securing it in high winds. We get our co-ordinance from www.dishpointer.com "before moving" to our next destination just in case we don't have Internet available. (We had no Verizon in Lake Havasu) With this system you wouldn't require a signal meter either. I align the mark on the mast between the True North and Magnetic North co-ordinance given and make a very small adjustment and Voila...done.
Steve, I purchased a DTV Dish on Amazon, it was pretty cheap and came with a compass and two Different mounting masts. I then purchased and inexpensive Toner Meter for locating the signal, it beeps. For mounting the dish on the ground I purchased a small 1.5 gallon plastic bucket, stuck a small piece of PVC in the bucket, poured cement around the PVC, my DTV mast slides right in the PVC, the weight of the concrete keeps the dish from tipping over and when I take it apart it's easy to store.....
We have been using a Wineguard Tripod and a Accutek III Meter with our Dish for almost a year now.
We setup the tripod using the bubble level on top, get a general idea of the satellite's heading, aim the dish a little to the west of the heading, connect the Accutek III Meter and start panning the dish to the east. Get a good strong signal on all 3 LNBs, lock the dish down.
I am even getting good at finding tripod locations at sites with a lot of trees.
Setup time start to finish is less than 5 minutes.
-- Edited by Rob_Fla on Sunday 23rd of December 2012 05:51:58 AM