Hi Everyone. Well, after 15 years the RV-Dreams Community Forum is coming to an end. Since it began in August 2005, we've had 58 Million page views, 124,000 posts, and we've spent about $15,000 to keep this valuable resource for RVers free and open. But since we are now off the road and have settled down for the next chapter of our lives, we are taking the Forum down effective June 30, 2021. It has been a tough decision, but it is now time.


We want to thank all of our members for their participation and input over the years, and we want to especially thank those that have acted as Moderators for us during our amazing journey living and traveling in our RV and growing the RV-Dreams Family. We will be forever proud to have been founders of this Forum and to have been supported by such a wonderful community. Thank you all!!

Members Login
Username 
 
Password 
    Remember Me  
Post Info TOPIC: magic chef oven problem


RV-Dreams Community Member

Status: Offline
Posts: 3
Date:
magic chef oven problem


Have a magic chef oven that will not keep temperature

if set to a temperature even when  I set to warm, it will just heat up to about 450

just replaced the thermostat and still have the same problem.   What else can it be?



__________________


RV-Dreams Family Member

Status: Offline
Posts: 1337
Date:

RV ovens are notorius for being inaccurate. I'm assuming you have a good oven thermometer to measure the actual heat.

The heat sensor is kind of fragile and must be positioned properly. When you replaced the themostat, hopefully it came with a new heat sensor. If not, you may need to replace it. If it did, make sure the heat sensor is in the proper position in the retaining clip.

Could the knob be on wrong, where it shows warm but is actually in the 450 degree range. I realize it's difficult to put the knob on wrong due to design, but I have seen it happen.

__________________

"Small House, Big Yard "

"May the FOREST be with you"
Alfa See-Ya 5'er and 2007 Kodiak C4500 Monroe



RV-Dreams Community Member

Status: Offline
Posts: 3
Date:

Thanks for your reply. Just checked heat sensor position and knob. No matter what temperature it is set to, it just keeps heating to the highest temp.

__________________


RV-Dreams Community Member

Status: Offline
Posts: 20
Date:

From my repair experiance most all oven themostats and the sensors are one combined unit, unless it is lit with a hot surface igniter. If it is the later then there is an oven safety valve in the gas line, usually at the inlet to the burner. I have found that sometimes that valve will stick open allowing gas to flow constantly to the oven burner causing no temp. control for the oven. If it is not electronic ignition then you may have gotten a control that is DOA, in which case should still be under warranty.

Be extremely careful with the sensing bulb capillary for it is very fragile. No kinking or extemely sharp bends.



__________________

'05 Dodge 3500 5.9, Banks exhaust brake, pulling '03 Alfa Sun 32' fifth wheel.



RV-Dreams Community Member

Status: Offline
Posts: 3
Date:

Is there any way to test the new thermostat to see if it is DOA?


__________________


RV-Dreams Community Member

Status: Offline
Posts: 20
Date:

When you purchased and installed the new thermostat was the sensing capillary tube and sensor attached to the thermostat? If it was and you were very careful with that sensing capillary tube and sensor and your still having no temperature regulation then it's a DOA.

That sensing capillary tube w/sensing bulb contains a small chemical charge that increases pressure as the temperature rises expanding a small bellows that closes off the gas flow, as the oven cools the pressure on the bellows decreases to a point that again allows gas flow.



__________________

'05 Dodge 3500 5.9, Banks exhaust brake, pulling '03 Alfa Sun 32' fifth wheel.

Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.

Tweet this page Post to Digg Post to Del.icio.us