Hi Everyone. Well, after 15 years the RV-Dreams Community Forum is coming to an end. Since it began in August 2005, we've had 58 Million page views, 124,000 posts, and we've spent about $15,000 to keep this valuable resource for RVers free and open. But since we are now off the road and have settled down for the next chapter of our lives, we are taking the Forum down effective June 30, 2021. It has been a tough decision, but it is now time.
We want to thank all of our members for their participation and input over the years, and we want to especially thank those that have acted as Moderators for us during our amazing journey living and traveling in our RV and growing the RV-Dreams Family. We will be forever proud to have been founders of this Forum and to have been supported by such a wonderful community. Thank you all!!
Hello everybody hope this does not come across as silly for all of you rv veterans out there.I live in Florida so I have used the heat once with electric hook up. My furnace is located on the thermostat which is electric. How would I use and control my heat if I am boondocking somewhere?
__________________
David Sussman lifeprotect123@gmail.com Will Travel in a 2002 coachman travel trailer and a 1995 F350
thunder it's all good! Keep in mind that a propane furnace setup will use some 15-20+amp DC when running. This can be a pretty heavy electrical load depending on your setup, furnace run time, other power consumption, and battery state. A hydronic furnace setup (i.e. Oasis, AquaHot) will use around 5-10amp DC.
Many boondockers get a catalytic or ceramic propane heater and a much better carbon monoxide (CO) detector to cut their electric usage to zero volts DC. Plus these heaters are more efficient and use much less propane since they are radiant heaters and have no fans. But if you hang out below freezing a bunch you better have sufficient batteries to run the furnace all night because you need it to keep your bays from freezing, since radiant heaters won't heat the basement. Since they are not vented you want a CO detector with a digital readout.
Note that ceramic propane heaters get flakey about 7,000 feet elevation and catalytic around 12,000 feet while most RV furnaces can handle these elevations.
-- Edited by bjoyce at 10:10, 2009-01-06
__________________
Bill Joyce, 40' 2004 Dutch Star DP towing an AWD 2020 Ford Escape Hybrid Journal at http://www.sacnoth.com Full-timing since July 2003
Thunder...keep in mind that on this forum there are no silly questions. The only thing silly is to not ask the question and go on not knowing the answer.